Microfreak/Preset/392 Blithrifi

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 392 over USB on October 25, 2026 with mise run microfreak:download --slot 392. Two consecutive reads returned the same file.
    • The parameter payload matches no MIDI Control Center factory archive.
    • Download the slot 392 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/392 Blithrifi/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: V.Analog. Microfreak/UG/06 Dig Osc/03 Types/06 VAnalog
    • Detune: 0.498. Shape: 0.498. Wave: 0.103.
    • Keyboard octave: -1. Glide: 0.284.

  • Filter

    • Low-pass filter. Saved cutoff: 0.228; resonance: 0.544. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.410, decay/release 0.351, sustain 0.350. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Loop. Stored RiseLvl 0.269, RiseSlp 0.500, FallLvl 0.190, FallSlp 0.500, Hold 0.444, Amount 0.704. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Sine, clock sync off; stored normalized rate: 0.505. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • Cycling Envelope → Pitch: +0.031.
    • KEY/ARP → Wave: +0.068.
    • PRESSURE → Timbre: +0.993.
    • ENV → Cutoff: +0.569.
    • LFO → Cutoff: +0.148.
    • PRESSURE → Assign 1 → Glide: +0.222.
    • PRESSURE → Assign 2 → LFO Rate: +0.392.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: off.

  • Customized controls

    • No factory preset is close. The nearest factory payload, Microfreak/Preset/313 Tremolo Saw (Factory 2.1 slot 60), differs in 25 controls.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.