Microfreak/Preset/362 TMF.24.11.18.C

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 362 over USB on October 25, 2026 with mise run microfreak:download --slot 362. Two consecutive reads returned the same file.
    • The parameter payload matches no MIDI Control Center factory archive.
    • Download the slot 362 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/362 TMF.24.11.18.C/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: BasicWaves. Microfreak/UG/06 Dig Osc/03 Types/01 BasicWaves
    • Morph: 0.504. Sym: 0.000. Sub: 0.563.
    • Keyboard octave: +1. Glide: 0.355.

  • Filter

    • Low-pass filter. Saved cutoff: 0.464; resonance: 0.405. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.450, decay/release 0.551, sustain 0.764. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Run. Stored RiseLvl 0.100, RiseSlp 0.500, FallLvl 0.380, FallSlp 0.500, Hold 0.044, Amount 0.485. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Sine, clock sync off; stored normalized rate: 0.962. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • Cycling Envelope → Wave: +1.000.
    • ENV → Cutoff: −0.240.
    • LFO → Cutoff: +0.194.
    • Cycling Envelope → Assign 1 → LFO Rate: −0.277.
    • PRESSURE → Assign 2 → matrix amount ENV → Cutoff: +0.521.
    • PRESSURE → Assign 3 → Cycling Envelope Amount: +0.349.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: off.

  • Customized controls

    • No factory preset is close. The nearest factory payload, Microfreak/Preset/172 Snare Four (Factory 2.0 slot 145), differs in 23 controls.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.