Microfreak/Preset/352 Lait

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 352 over USB on October 25, 2026 with mise run microfreak:download --slot 352. Two consecutive reads returned the same file.
    • The parameter payload matches no MIDI Control Center factory archive.
    • Download the slot 352 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/352 Lait/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: SawX. Microfreak/UG/06 Dig Osc/03 Types/15 SAWX
    • Saw Mod: 0.120. Shape: 0.113. Noise: 0.000.
    • Keyboard octave: +1. Glide: 0.000.

  • Filter

    • Low-pass filter. Saved cutoff: 0.409; resonance: 0.000. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.000, decay/release 0.401, sustain 0.560. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Run. Stored RiseLvl 0.167, RiseSlp 0.500, FallLvl 0.163, FallSlp 0.500, Hold 0.000, Amount 1.000. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Triangle, clock sync on; stored division code: 7. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • ENV → Wave: −0.244.
    • ENV → Timbre: −0.042.
    • PRESSURE → Timbre: −0.274.
    • ENV → Cutoff: +0.118.
    • LFO → Cutoff: +0.048.
    • PRESSURE → Cutoff: +0.216.
    • PRESSURE → Assign 1 → Filter Resonance: +0.730.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: on.

  • Customized controls

    • Every control listed on this page matches the nearest factory payload, Microfreak/Preset/247 Laity (Factory 3.0 slot 315); the saved payload differs only in settings these sections do not show.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.