Microfreak/Preset/350 Smooth IPA

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 350 over USB on October 25, 2026 with mise run microfreak:download --slot 350. Two consecutive reads returned the same file.
    • The parameter payload matches no MIDI Control Center factory archive.
    • Download the slot 350 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/350 Smooth IPA/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: Bass. Microfreak/UG/06 Dig Osc/03 Types/14 BASS
    • Saturate: 0.056. Fold: 0.000. Noise: 0.000.
    • Keyboard octave: 0. Glide: 0.000.

  • Filter

    • Low-pass filter. Saved cutoff: 0.499; resonance: 0.120. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.104, decay/release 0.751, sustain 0.083. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Loop. Stored RiseLvl 0.461, RiseSlp 0.500, FallLvl 0.486, FallSlp 0.500, Hold 0.000, Amount 1.000. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Sine, clock sync off; stored normalized rate: 0.400. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • Cycling Envelope → Pitch: +0.004.
    • LFO → Pitch: −0.002.
    • KEY/ARP → Pitch: −0.010.
    • ENV → Cutoff: +0.474.
    • LFO → Cutoff: −0.085.
    • LFO → Assign 2 → Sustain: +1.000.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: on.

  • Customized controls

    • Every control listed on this page matches the nearest factory payload, Microfreak/Preset/281 Smooth IPA (Factory 3.0 slot 346); the saved payload differs only in settings these sections do not show.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.