Microfreak/Preset/273 Good

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 273 over USB on October 25, 2026 with mise run microfreak:download --slot 273. Two consecutive reads returned the same file.
    • The parameter payload matches the MIDI Control Center archives Factory 3.0, Factory 6.0 (Factory 3.0 slot 339, Factory 6.0 slot 420). Comparison used mise run microfreak:compare.
    • Download the slot 273 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/273 Good/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: Harm. Microfreak/UG/06 Dig Osc/03 Types/16 HARM
    • Spread: 0.564. Rectification: 0.224. Noise: 0.023.
    • Keyboard octave: 0. Glide: 0.000.

  • Filter

    • Low-pass filter. Saved cutoff: 0.810; resonance: 0.333. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.952, decay/release 0.718, sustain 1.000. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Env. Stored RiseLvl 0.677, RiseSlp 0.500, FallLvl 0.381, FallSlp 0.500, Hold 1.000, Amount 0.416. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Sine, clock sync on; stored division code: 0. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • PRESSURE → Wave: +0.019.
    • Cycling Envelope → Timbre: +1.000.
    • LFO → Timbre: +0.110.
    • ENV → Cutoff: +0.103.
    • LFO → Cutoff: +0.047.
    • PRESSURE → Assign 1 → Noise: +0.565.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: on.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.