Microfreak/Preset/247 Laity

• Notes

  • SawX lead with envelope-shaped saw modulation, chorus and expression-controlled filter resonance.

  • Saved export and provenance

    • Saved export: September 28, 2026 MIDI Control Center user-bank archive, computer-bank slot 315, file 315-09282026 6h14-A315.mbp. The computer-bank slot differs from this page’s observed device slot.
    • The parameter payload matches Factory 3.0 and 6.0. This is an archived factory-equivalent baseline; it does not establish the instrument’s saved or unsaved state during a later session.

  • Oscillator

    • Model: SAWX. Saw Mod controls a modulus stage; Shape controls chorus amount; Noise adds phase modulation from subsampled white noise.
    • Saw Mod: 0.120.
    • Shape: 0.113.
    • Noise: 0.000.

  • Filter

    • Low-pass filter. Saved cutoff: 0.409; resonance: 0.000. Cutoff and resonance are normalized settings, not hertz or instrument display values.

  • Envelopes

    • Main envelope: attack 0.000, decay/release 0.401, sustain 0.560. Amp Mod is on, so the main envelope controls loudness.
    • Cycling Envelope mode: Run. Stored RiseLvl 0.167, FallLvl 0.163, Hold 0.000, Amount 1.000. These are normalized stored fields; rise/fall times in milliseconds remain unverified.

  • LFO

    • Triangle; clock sync on. Stored normalized rate: 0.148; division code: 7. The rate is not a hertz reading, and the musical division has not been converted.

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. The assignment destinations below resolve the saved Assign columns.
    • ENV → Wave / Saw Mod: −0.244. The main envelope reduces saw modulation.
    • ENV → Timbre / Shape: −0.042. The main envelope reduces chorus amount.
    • PRESSURE → Timbre / Shape: −0.274. Expression reduces chorus amount.
    • ENV → Cutoff: +0.118. The main envelope opens the filter.
    • LFO → Cutoff: +0.048. The triangle LFO changes filter brightness.
    • PRESSURE → Cutoff: +0.216. Expression opens the filter.
    • PRESSURE → Assign 1 → Resonance: +0.730. Expression increases filter resonance.
    • All other saved matrix amounts are zero.

  • Performance and session context

    • Expression increases cutoff and resonance while reducing chorus amount. The main envelope changes the saw modulation, chorus and filter together.
    • Paraphonic mode is on in the saved export. The PRESSURE matrix row uses pressure or velocity according to the instrument’s global Utility setting; the export does not establish which expression source was used in the session.
    • GitP/A/Session/26/10/12-Mon references this sound. The session context does not identify which recording passages use it.

  • Evidence and interpretation

    • Base controls use normalized 0…1 values unless a stored choice code is shown; matrix amounts use −1…+1. These describe saved base settings, before modulation, and are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix columns and assignments follow the Freakout live map and assignment decoder. Mode and waveform labels follow the MicroFreak Reader definitions.
    • Microfreak/UG/06 Dig Osc/03 Types/15 SAWX describes oscillator controls. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations explains the matrix and expression row.