Microfreak/Preset/216 Rubber Band

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 216 over USB on October 25, 2026 with mise run microfreak:download --slot 216. Two consecutive reads returned the same file.
    • The parameter payload matches the MIDI Control Center archives Factory 3.0, Factory 6.0 (Factory 3.0 slot 287, Factory 6.0 slot 215). Comparison used mise run microfreak:compare.
    • Download the slot 216 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/216 Rubber Band/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: Bass. Microfreak/UG/06 Dig Osc/03 Types/14 BASS
    • Saturate: 0.240. Fold: 0.362. Noise: 0.086.
    • Keyboard octave: 0. Glide: 0.145.

  • Filter

    • Low-pass filter. Saved cutoff: 0.138; resonance: 0.629. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.000, decay/release 0.572, sustain 0.689. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Run. Stored RiseLvl 0.094, RiseSlp 0.500, FallLvl 0.324, FallSlp 0.500, Hold 0.000, Amount 0.050. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Triangle, clock sync on; stored division code: 4. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • LFO → Timbre: +0.393.
    • Cycling Envelope → Cutoff: +0.074.
    • ENV → Cutoff: +0.725.
    • LFO → Cutoff: −0.626.
    • KEY/ARP → Cutoff: +0.507.
    • KEY/ARP → Assign 1 → Cycling Envelope Rise: +0.237.
    • KEY/ARP → Assign 2 → Mat.Assign2: +0.507.
    • PRESSURE → Assign 3 → LFO.Div: +0.461.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: off.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.