Microfreak/Preset/211 Motorway

• Notes

  • Saved export and provenance

    • Saved export: read from the device's slot 211 over USB on October 25, 2026 with mise run microfreak:download --slot 211. Two consecutive reads returned the same file.
    • The parameter payload matches the MIDI Control Center archives Factory 3.0, Factory 6.0 (Factory 3.0 slot 282, Factory 6.0 slot 361). Comparison used mise run microfreak:compare.
    • Download the slot 211 capture. It is the raw device format (header plus data packets), not an .mbp file; see Microfreak/Preset/211 Motorway/Asset/Device-Read-2026-10-25/bin.

  • Oscillator

    • Model: Harm. Microfreak/UG/06 Dig Osc/03 Types/16 HARM
    • Spread: 0.526. Rectification: 0.726. Noise: 0.334.
    • Keyboard octave: 0. Glide: 0.000.

  • Filter

    • Low-pass filter. Saved cutoff: 0.602; resonance: 0.570. Microfreak/UG/07 Filter/01 Modifying Sound/01 Low Pass Filter

  • Envelopes

    • Main envelope: attack 0.000, decay/release 0.329, sustain 0.279. Amp Mod is on, so the main envelope controls loudness. Microfreak/UG/09 Envelope Gen/03 Envelope Stages
    • Cycling Envelope mode: Run. Stored RiseLvl 0.371, RiseSlp 0.000, FallLvl 0.290, FallSlp 0.479, Hold 0.364, Amount 0.206. Microfreak/UG/09 Envelope Gen/06 Cycling Envelope

  • LFO

    • Triangle, clock sync off; stored normalized rate: 0.175. Microfreak/UG/08 LFO/01 LFO Shape · Microfreak/UG/08 LFO/02 LFO Rate

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations
    • Cycling Envelope → Wave: +0.060.
    • LFO → Wave: +0.003.
    • Cycling Envelope → Timbre: +0.144.
    • LFO → Timbre: −0.218.
    • Cycling Envelope → Cutoff: −0.660.
    • ENV → Cutoff: +1.000.
    • ENV → Assign 1 → Cycling Envelope Amount: +0.213.
    • All other saved matrix amounts are zero.

  • Voice and keyboard

    • Paraphonic mode: on.

  • Evidence and interpretation

    • Values describe saved base settings before modulation. Controls use normalized 0…1 values unless a stored choice code is shown; they are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix assignments follow the Freakout live map. Mode, LFO shape, filter type and octave labels follow the MicroFreak Reader definitions.