Microfreak/Preset/077 Eonz

• Notes

  • SuperWave lead with expression-controlled waveform selection and note length.

  • Saved export and provenance

    • Saved export: September 28, 2026 MIDI Control Center user-bank archive, computer-bank slot 160, file 160-09282026 6h14-A160.mbp. The computer-bank slot differs from this page’s observed device slot.
    • The parameter payload matches Factory 1.1, 2.1, 3.0 and 6.0. This is an archived factory-equivalent baseline; it does not establish the instrument’s saved or unsaved state during a later session.
    • Download the archived Eonz preset.

  • Oscillator

    • Model: SuperWave. Wave chooses saw, square, triangle or sine; Timbre changes detuning; Shape changes the volume of the detuned copies.
    • Wave: 3 (stored choice code).
    • Detune: 0.440.
    • Volume: 0.353.

  • Filter

    • Low-pass filter. Saved cutoff: 0.187; resonance: 0.415. Cutoff and resonance are normalized settings, not hertz or instrument display values.

  • Envelopes

    • Main envelope: attack 0.000, decay/release 0.300, sustain 0.000. Amp Mod is on, so the main envelope controls loudness.
    • Cycling Envelope mode: Run. Stored RiseLvl 0.055, FallLvl 0.057, Hold 0.000, Amount 1.000. These are normalized stored fields; rise/fall times in milliseconds remain unverified.

  • LFO

    • Triangle; clock sync on. Stored normalized rate: 0.148; division code: 1. The rate is not a hertz reading, and the musical division has not been converted.

  • Modulation matrix

    • Amounts use the signed normalized range −1…+1. The assignment destinations below resolve the saved Assign columns.
    • PRESSURE → Wave: −1.000. Expression moves the SuperWave waveform selection.
    • ENV → Timbre / Detune: −0.430. The main envelope reduces detuning.
    • ENV → Cutoff: +0.471. The main envelope opens the filter.
    • PRESSURE → Assign 1 → Decay/Release: +0.561. Expression lengthens the main envelope decay/release.
    • All other saved matrix amounts are zero.

  • Performance and session context

    • The saved main envelope has an immediate attack and no sustained level. Expression changes both waveform selection and decay/release. The Cycling Envelope, LFO and Key/Arp rows have no nonzero matrix routes in this export.
    • Paraphonic mode is on in the saved export. The PRESSURE matrix row uses pressure or velocity according to the instrument’s global Utility setting; the export does not establish which expression source was used in the session.
    • GitP/A/Session/26/10/20-Tue references this sound.

  • Evidence and interpretation

    • Base controls use normalized 0…1 values unless a stored choice code is shown; matrix amounts use −1…+1. These describe saved base settings, before modulation, and are not OLED percentages, hertz or milliseconds.
    • The saved-parameter inspector preserves the original fields. Oscillator interpretation assumes the documented firmware 5 layout; firmware is not detected from the export.
    • Matrix columns and assignments follow the Freakout live map and assignment decoder. Mode and waveform labels follow the MicroFreak Reader definitions.
    • Microfreak/UG/05 Connections/02 Matrix and Encoder/01 Sources and Destinations explains matrix sources, destinations and the expression row.